IHybrid Maintenance

Page last edited 4,126 days ago
From Hybrid APV Wiki
Jump to navigation Jump to search
This page is a stub and requires more content added as soon as possible.
This page contains information about maintenance and care for your iHybrid. It is not an official support site. Use the advice found here at your own risk. All questions about maintenance and repairs need to be addressed to the manufacturer.

iHybrid "classic" (versions 1.x - 2.x)

Basic Specs

Diameter of iHybrid = .985" x 25mm

Wick hole measurement: 3.08mm and height is 50ish mm

Tank Replacement Measurements: 3/4 ID, 7/8 OD with 1/16" wall and 1 & 5/16" tall (See same post for Dimensions)

Thread size and pitch of positive screw: Thread size is 6-32 and 1/8" long, can use a 6s (s=small) washer (only 1mm thick)

Tank will hold 2.7 to 3 mil range

Mesh Size 1.67" wick or 42.63mm

Standard o-rings are 5/8" OD with a 1/16. The extra ring that Faceless sends with super snug fit is 11/16 OD with a 1/16 wall

Magnet assortment/configuration that is sent with iHybrid


Springs

The springs are all custom cut. I got them at TSC (tractor supply company) They are in an assortment box for $5 and you can make about 10 springs from the box. They are the black ones and need to be cut right in the middle. They will stand .500" tall after cut right. I will probably just find a spring provider for the size I need [1]





References